Hi,
For some reason in SW2009 the option to print 100% from a part or assembly has gone. Is this an 'improvement' or is it something with my settings?
You have been able to do this for YEARS, so why has it stopped now?
Cheers, Lee
You have to set that in page setup. then you have to go to print preview to see what you have. you need to go to print to setup your printer.
First set up the printer. Close without printing. Set your scale in page setup. Check your results in print preview. Print if it is what you want. Close and go back to page setup if it is not.
Bob
Install SW2009, SP3.0 and it will be back.
Cheers,
Anna
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.