Atlas Switch Machine Doesn't Quite Fit


I'm wondering why the Atlas L remote switch machine doesn't quite fit properly to the #4 L turnout. The tie with the notch nearest the throw rod seems a bit short and is bent upward slightly with the switch machine in place. It isn't a snug fit.

What am I overlooking? Thanks.

-- Pete

Reply to
Loading thread data ...

Probably bit of flash (thin strip of plastic along the parting line of the mold), or minor molding error. Take the machine off, examine both it and the switch closely. Judicious use of file and knife will make the machine fit.


Reply to
Wolf K.

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.