SoCal TIG Seminar, Let's set this up!

Too bad this is on the wrong coast for me. I would LOVE to be able to attend one or both weekends. Any plans for an east coast workshop?

Jim

Im in. And the offer host is still open, at one of my clients

Gunner

This Message is guaranteed environmentally friendly Manufactured with 10% post consumer ASCII Meets all EPA regulations for clean air Using only naturally occuring fibers Use the Message with confidance. (Some settling may occure in transit.) (Best if Used before May 13, 2009)

I have relatives in Baltimore and North of Boston, but little connection to them. I can't honestly think of a job related reason to visit the East Coast.

If the seminar could fund itself so it cost me little or nothing to run it, I might be interested.

I have a brother in northern VA that I could squat with if you had one in MD. That would probably be the most central place on the east coast to have it. What would it cost to make it worth your while?

Travel $, housing, food? Probably around $1000 - $1500. Depends how long the seminar took , and if any equipment would need to be rented.

Cool. I could kick in $100 or so. It would just be a matter of getting enough people in on it.

This could be a worthwhile thing for me to attend. Anaheim's not that far from me, and I can always benefit from some additional learning. Plus it'd be worth it just to meet Ernie and Gunner.

Please count me in. I will either drive or fly over from Phoenix.

Thanks, Bob Harbour