⚡ Welding Forums

  1. Home
  2. ⚡ Welding Forums
6251 Threads Posts
to

weld-on trailer jack

I bought a bulldog swivel jack with a weld-on L shaped bracket. The bracket has 4 small bumps on the plate that prevent...
3 comments posted 22yrs
posted by bitternut
3 comments posted 22yrs posted by bitternut

flash

hello as im typing this my eyes are streeming with tears and gritty feeling and sore to move is there any thing i can u...
21 comments posted 22yrs
posted by westmclaren
21 comments posted 22yrs posted by westmclaren

HTP Plasma Cutters

Has anyone here tried these out? They seem much more reasonably priced thatn other units with the same capabilities.
0 comments posted 22yrs
posted by mesocycln1
0 comments posted 22yrs posted by mesocycln1

Question on welding leads.

Maybe someone with experience can stop me from making a mistake lengthening my welding leads..... My welder is a 225 ac...
34 comments posted 22yrs
posted by elsewhere
34 comments posted 22yrs posted by elsewhere

Brazing using flux powder

I just ordered some bare Allstate 11 brazing rod and while I hope to tig braze with it, I also bought some powdered flu...
16 comments posted 22yrs
posted by brian.evans
16 comments posted 22yrs posted by brian.evans

Welder OCV Question

I have a 300 amp GE gas drive DC welder I just got running,I can only get 64 volts OCV With no load,with control settin...
4 comments posted 22yrs
posted by cdlale
4 comments posted 22yrs posted by cdlale

Linde welder UCC 305

Hi, I recently purchased one of these monsters on Ebay. Can someone with experience chime in about performance and such...
18 comments posted 22yrs
posted by mesocycln1
18 comments posted 22yrs posted by mesocycln1

Plasma Clearance

What distance should the tip be away from the material when cutting thin 2mm plate please.
0 comments posted 22yrs
posted by welder
0 comments posted 22yrs posted by welder

Jackson NexGen

I know the auto darkening hood thing has been discussed here at length-but I do have a question. I've recently got a ye...
3 comments posted 22yrs
posted by brad254
3 comments posted 22yrs posted by brad254

Rod oven

Anyone have plans for a homemade rod oven for a small shop. I don't need to store a hundred pounds but need enough for s...
5 comments posted 22yrs
posted by VE1BNG
5 comments posted 22yrs posted by VE1BNG

HD cylinder head repair?

Wonder if anyone can help with info regarding the best rod to use for tig welded repair of an aluminuim head from a Har...
3 comments posted 22yrs
posted by ertumk
3 comments posted 22yrs posted by ertumk

SIP TIG Welder

Has anyone had any experience with the SIP TIG 160 AC/DC welder? (specifically, the one halfway down this page http://w...
1 comments posted 22yrs
posted by jsmith
1 comments posted 22yrs posted by jsmith

230v Service Question

I have been reading about various arc welders (specifically lincoln ac-225 and miller xl225) and noticed that they both...
19 comments posted 22yrs
posted by google
19 comments posted 22yrs posted by google