Is it possible to connect a servo with Z connector to a Futaba receiver that
uses J connectors?
- posted 17 years ago
How to use Z connector servos with Futaba J?
Loading thread data ...
- posted 17 years ago
Yes, just plug it in but observe the polarity because it can go either way.
The black wire is to the outside (end) of the receiver.
- posted 17 years ago
Or buy an Airtronics adapter cable.
- posted 17 years ago
Oops, disregard. For some reason I was thinking old Airtronics plugs,
Duh Don
Duh Don
Site Timeline
-
Air Alert
- Hello, I got one of these on a used airplane, could someone tell me how it...
- next in
✈ RC aircraft models
-
Silencer for Super Tigre G2000
- I'm after a decent silencer for an ST G2000. The one fitted has been decsribed...
- previous in
✈ RC aircraft models
-
Where'd everybody go?
- Anyone listening? On Tue, 21 Dec 2021 21:04:06 -0500, m-m wrote as underneath :...
- last updated in
✈ RC aircraft models
-
Where'd everybody go?
- Anyone listening? On Tue, 21 Dec 2021 21:04:06 -0500, m-m wrote as underneath :...
- last posted in
✈ RC aircraft models
-
Stripper Disc: Getting More First Minutes Out of A Flap Disc
- >> >>>> Yesterday I found myself cleaning up a bit of square tube in >>>>...
- site's last updated in
⏣ General Metalworking
-
to tylko początek niezwykłych rozwiązań
- Grawitacja pomaga wytwarzać światło, a to tylko początek niezwykłych...
- site's newest in
Engineering Science (Polish)