1. Home
  2. ⋐⋒⋐ Computer Numeric Control
  3. strange emco 325 issue

strange emco 325 issue

am having a strange error with my Emco 325 with a Fanuc 0-T control

When I run a program we get a 1024 and 1029 alarm. The 1029 is a parity monitoring alarm (not in manual), the 1024 is a tool monitoring error. Emco thinks it is a turret alarm..BUT the turret seems to be turning fine, the tool goes into correct position. . Any help would be GREATLY appreciated

Reply to
Ratedr
Loading thread data ...

Turret encoder may use a parity bit , the above alarms are not Fanuc but end user alarms. You can view the ladder to get the source of the alarms.

Regards db

Reply to
Dave B

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.