I need to find information on the design of plain bearings, as used on engine crankshafts.
I want look at changing two four cylinder engines in to a V 8 engine.
The con rod bearings on the crank will need to be of a larger diameter and smaller width than the original engine.
I need a text or web sight that will give me information on load capacity, related to, pressure of oil feed, width, diameter etc for the bearings.
I want enough explanation of theory to understand any formulas, but a practical approach to design is what I really need.
I would also like to find information on connecting rods, as a one off set will be very expensive and design round a suitable existing rod could save a lot of trouble and cost.
-- Jonathan
Barnes's theorem; for every foolproof device there is a fool greater than the proof.
To reply remove AT