1. Home
  2. ⏣ General Metalworking
  3. Anyone Have an Okuma Lathe / Machining Center?

Anyone Have an Okuma Lathe / Machining Center?

I'm looking for some specs I can't get from them so far or from the web...

Specifically, I'm looking for info on the L300M with the VDI40 and 600H machining center with CAT50...

I'd love to give you a call and/or get some digital photos from someone and would be willing to talk cost to do this for me.

Thanks for any help anyone can offer.

Regards, Joe Agro, Jr. (800) 871-5022

01.908.542.0244 Automatic / Pneumatic Drills:
formatting link
Spindle Drills:
formatting link
Tapping:
formatting link
Site:
formatting link
formatting link
formatting link
formatting link
V8013-R
Reply to
Joe AutoDrill
Loading thread data ...

I bet nobody on this NG has a CAT50 machine.

Karl

Reply to
Karl Townsend

We have a L370M Captain, not the same thing but this is a live tool lathe. No idea if it is close.

Wes

Reply to
Wes

Does a Van Norman #36 count?

formatting link
Gunner

Whenever a Liberal utters the term "Common Sense approach"....grab your wallet, your ass, and your guns because the sombitch is about to do something damned nasty to all three of them.

Reply to
Gunner Asch

Close enough. Man, I'd like to see that thing making a deep cut with a carbide face mill.

Karl

Reply to
Karl Townsend

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.