Hi,
Any recommended software (preferably free) that takes X,Y coordinates from an Excellon file and creates G81 drill cycle code blocks? I can write a program to do this but why reinvent the wheel?
Hi,
Any recommended software (preferably free) that takes X,Y coordinates from an Excellon file and creates G81 drill cycle code blocks? I can write a program to do this but why reinvent the wheel?
How about windows Notepad? G81 is modal, write the first hole by had to get your R Z and F parameters. Then cut and paste all the other lines into the file. Next, use find and replace to to put in the X and Y in every line.
Karl
How about windows Notepad?
Doing that now in another editor.
script.exe
or something similar is what I'm looking for.
"Karl Townsend" wrote in message news:z2sge.934$ snipped-for-privacy@newsread2.news.pas.earthlink.net...
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.