drawer cabinet and hangmaps

I have used verticle hanging D size and E size drawing cabinets in Engineering. We had 1 lateral but hated the drawer system.

The hangers are simply boxes as wide and as long as you need. The depth depends on your method.

The top have racks on each side. They are in wood something like a 2" board that has circles cut into each side such that they are open on the long (top) side and are a half circle.

Into these half circles are rods. Typically maple rods. There are clips that extend over the rods and below to hold with. (I'd depart here - hang the clips from the rod.

Now the important thing - across the now top of the page - you pick the top dimension - The artwork / photo / map / etc is held between two plastic sheets. These sheets grip the art. The clips grips the plastic. (plastic doesn't rust...) And the point pressure of a clip is spread out with the plastic.

I don't have access to the files anymore, but I suspect you could search for them.

Martin

Another method is just like a pants hander from the local cleaners. But have an open end and a large diameter - requires a rounded bend but shortens file sizes.

Martin

OK, thanks.