FS Tool cabinets from tool supply

These 12 drawer units were originally built to hold IBM punch cards. They are fully roller suspended, with removable drawer liners. Super heavy duty. For details see add on craigs list below.

formatting link

Reply to
Scott
Loading thread data ...

formatting link

Ive got 16 of them currently. Most Ive ever paid was $35 each. But good luck on your endeavor.

Gunner

This Message is guaranteed environmentally friendly Manufactured with 10% post consumer ASCII Meets all EPA regulations for clean air Using only naturally occuring fibers Use the Message with confidance. (Some settling may occure in transit.) (Best if Used before May 13, 2009)

Reply to
Gunner

formatting link

I sold two similar cabinets recently. Mine were about 24" wide. (going by memory). They fetched $95 each, far from what the OP was asking.

i
Reply to
Ignoramus32070

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.