⏣ General Metalworking

30777 Threads Posts
to

Concave radius cutter

Awl-- I'm using a std 3/8 radius concave cutter, 3/4 shank. The head is about 1" OD, which causes some clearance proble...
2 comments posted 21yrs
posted by physical
2 comments posted 21yrs posted by physical

spindle

looking for spindle assy. for china imprt 12 speed drill press...............hate to throw it away
6 comments posted 21yrs
posted by chevy3755
6 comments posted 21yrs posted by chevy3755

New to hydraulics - question 1 of many

I am learning about hydraulics presently and am fascinated by their simplicity and potential. There are a number of iss...
6 comments posted 21yrs
posted by murphy
6 comments posted 21yrs posted by murphy

Tap & Die for hose threads

Does anyone know where I could get a tap to cut 3/4 inch hose threads? Thanks.
4 comments posted 21yrs
posted by stone75
4 comments posted 21yrs posted by stone75

well-setting power feed info / parts needed

We have now gotten the J-head Bridgeport moved and back in operation at the new location at our college. During the mov...
7 comments posted 21yrs
posted by gmcduffee
7 comments posted 21yrs posted by gmcduffee

What is it called?

What is it called when a shaft running in sleeve bearings suddenly makes a loud grating sound and slows way down? I hav...
13 comments posted 21yrs
posted by chuckolson01
13 comments posted 21yrs posted by chuckolson01

treadmill motor

Several years ago I bought 2 treadmill motors from Surplus center after hearing about them on this NG. I put one on my...
2 comments posted 21yrs
posted by engineman1
2 comments posted 21yrs posted by engineman1

Dyna Mechtronics group

Hi, Just wanted to remind everyone that there is a new yahoo group just for Dyna Mechtronics users. We have a Dyna Mech...
0 comments posted 21yrs
posted by russw
0 comments posted 21yrs posted by russw

PING: Gunner

I need some linear rail stuff. I need 4" stroke by 1" or so wide for a wire feed. I remember you saying that you might h...
28 comments posted 21yrs
posted by tom(nospam)
28 comments posted 21yrs posted by tom(nospam)

Open vs enclosed motor for a belt sander

Just wondering if anyone in the group has any experience with or thoughts on using an open motor for a belt sander. Thi...
15 comments posted 21yrs
posted by no_spam
15 comments posted 21yrs posted by no_spam

Homemade hydralic press?

I have some left over 4" channel from my diesel generator project I recently completed and was about to begin another p...
9 comments posted 21yrs
posted by SomeOne
9 comments posted 21yrs posted by SomeOne

Ping Steve Paterson

Did you get the reply to my email about the lathe? I got an undeliverable bounce back to my mail box Gunner Liberals -...
4 comments posted 21yrs
posted by gunnerNOSPAM
4 comments posted 21yrs posted by gunnerNOSPAM

flattening curved sheet steel

I made a small curbside find today, a 3" stack of sheet steel pieces with a "FREE" sign taped to them. So into the truc...
8 comments posted 21yrs
posted by tove
8 comments posted 21yrs posted by tove

How to make a die using a tap

I have found a 12-20 tap and need to make a matching die. Any suggestions on how to proceed using a drill press and hand...
10 comments posted 21yrs
posted by joel.watson
10 comments posted 21yrs posted by joel.watson