⏣ General Metalworking

30777 Threads Posts
to

35 amp transformer wanted

I build 10-11 volt power supplies for my repeater's transmitters. Since they pull around 20-25 amps I've been using 35...
1 comments posted 21yrs
posted by wa7ycp
1 comments posted 21yrs posted by wa7ycp

aluminum casting question?

I need to have a small part casted out of aluminum 6061. The part consists of all round tubing. I'm welding 1 1/4" roun...
1 comments posted 21yrs
posted by rick
1 comments posted 21yrs posted by rick

WTB: # 6 Brown & Sharpe Dead Center

Hi just got my Hjorth lathe running and need a dead center. Anyone else have one of these lathes? Please rely to mcswfl...
3 comments posted 21yrs
posted by mcswfl
3 comments posted 21yrs posted by mcswfl

OT-Hollywierd Fact or fiction?

Posted with no comment "In contrast to the ideals, opinions and feelings of today's "Hollywonk" the real actors of yest...
80 comments posted 21yrs
posted by gunner
80 comments posted 21yrs posted by gunner

Soldering motor windings

I need to change an old 3-phase 1hp motor from star to delta configuration. Unlike newer motors, this one has only 4 te...
14 comments posted 21yrs
posted by binswood
14 comments posted 21yrs posted by binswood

What key for this chuck?

I just got a drill chuck marked RJ3-16L It's a 5/8 chuck. What key will fit this chuck? BTW Is it any way I can check if...
3 comments posted 21yrs
posted by alexkuzn
3 comments posted 21yrs posted by alexkuzn

Zamac bar stock?

Does anyone sell Zamac bar stock? I'm doing some repairs on a little sliding table saw and there's a little flange on t...
4 comments posted 21yrs
posted by MichaelHenry
4 comments posted 21yrs posted by MichaelHenry

Homier metal bender any good?

I'm pondering the purchase of a bender at the Homier sale this weekend. Their hand bender with stand is $39.95, a no-br...
13 comments posted 21yrs
posted by novalidaddress
13 comments posted 21yrs posted by novalidaddress

FA Dexter Valve Reseating Machine Lathe

See: http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=41369&item=8187814937&rd=1
0 comments posted 21yrs
posted by wrichadr2
0 comments posted 21yrs posted by wrichadr2

Steel hardening

Looking at the posts on metal hardening I was wondering what are the dynamics of oil versus water hardening.What is hap...
5 comments posted 21yrs
posted by SAYWAT
5 comments posted 21yrs posted by SAYWAT

What is this object?

Hi, I think this newsgroup is probably the best place to try and work out what this is. It was found on landfill in the...
11 comments posted 21yrs
posted by cybergibbons
11 comments posted 21yrs posted by cybergibbons

Sweating ball valves

Awl-- Hopefully my last plumbing Q! Man, am I buried here! I have previously screwed up sweating ball valves, and frank...
26 comments posted 21yrs
posted by physical
26 comments posted 21yrs posted by physical

Drillscrew or drill screw for thick metal

I am looking for ways to attach components to the floor of a truck. The floor could be as much as 1/4" thick plate with...
9 comments posted 21yrs
posted by eganders
9 comments posted 21yrs posted by eganders