⏣ General Metalworking

30778 Threads Posts
to

Threaded Rod Expert Out There?

I have a unique challenge at hand. I need to find 1/2 or greater diameter threaded rod in the following thread pitch co...
10 comments posted 21yrs
posted by spam.news.spam.individual.net
10 comments posted 21yrs posted by spam.news.spam.individual.net

acme thread for large wood screw

I want to make a wood screw for a vise(2in. dia). I have tried using dried and green oak and 3 tpi. The threads for the...
22 comments posted 21yrs
posted by boka
22 comments posted 21yrs posted by boka

project car

http://www.tetu.co.jp/RW930_F_1.jpg too bad this ones done
0 comments posted 21yrs
posted by erty0
0 comments posted 21yrs posted by erty0

Micro-Mark variable speed drill press

Have one of the above and just got off the phone complaining to Micro-Mark about the drive belts for the unit. Got mine...
5 comments posted 21yrs
posted by oparr
5 comments posted 21yrs posted by oparr

phase converter and transformer question

I latched onto an older horizontal mill that runs on 3hp 440V 3ph power. My plan is to hook up a 220V rotary phase conv...
28 comments posted 21yrs
posted by flyhigh
28 comments posted 21yrs posted by flyhigh

How come your shop smells so funny? Part II

Some of you may remember the last time I asked this question. I ended up crushing cedar cuttings in the hydraulic press...
14 comments posted 21yrs
posted by doc
14 comments posted 21yrs posted by doc

Drill bits for starting holes?

I remember that in Russia, there were special drill bits to start holes. They had a thick shank and sharp (think 40 deg...
11 comments posted 21yrs
posted by ignoramus5102
11 comments posted 21yrs posted by ignoramus5102

English wheel PLANS FREE !!!!!!!

I am looking for plans on a English Wheeel.... FREE of course Anyone out there want to help ?????
4 comments posted 21yrs
posted by lilsquir
4 comments posted 21yrs posted by lilsquir

Which rolling toolbox?

I have finally realized that I really need a large rolling toolbox. I have been buying and building tools pretty steadi...
18 comments posted 21yrs
posted by fergusonOMITsculpture
18 comments posted 21yrs posted by fergusonOMITsculpture

7/16" - 10 left handed Acme tap needed

Can't find anywhere. Anyone on the forum know of a source -- J. Mark Wolf
4 comments posted 21yrs
posted by J.Mark.Wolf.1he1fn
4 comments posted 21yrs posted by J.Mark.Wolf.1he1fn

What is it? XL

Just added some new photos and answers to the last set: http://puzzlephotos.blogspot.com/
82 comments posted 21yrs
posted by rhvp67
82 comments posted 21yrs posted by rhvp67

source for wheels for Baldor "carbide grinder"?

I picked up a Baldor carbide grinder today. The wheels are unusable, far too worn to do anything useful, they look sort...
3 comments posted 21yrs
posted by grant
3 comments posted 21yrs posted by grant

need EMCO F1 CNC mill manual

Does anyone know where these are available...cheap? I have 2 actually, one is for the Compact 5, the one that says "BAS...
2 comments posted 21yrs
posted by chrism3667
2 comments posted 21yrs posted by chrism3667