⏣ General Metalworking

30778 Threads Posts
to

Orphan McMaster Catalog

Hi All, I remember when this McMaster catalogs where a near constant topic of discussion around here. I have not notice...
2 comments posted 22yrs
posted by alanganes
2 comments posted 22yrs posted by alanganes

Painting question

My son-in-law (the good one) brought me a Sears oil crank compressor, about 100' of hose with quick connects, and three...
1 comments posted 22yrs
posted by desertNOtravelerSPAM
1 comments posted 22yrs posted by desertNOtravelerSPAM

Glass Lathe

Here's a link to a home made glass lathe. http://www.big-list.com/glasslathe.html Earle Rich Mont Vernon, NH
2 comments posted 22yrs
posted by erich10983
2 comments posted 22yrs posted by erich10983

Stainless steel tube forming assistance required

I am looking to get a 1 off piece made from stainless steel tube, not sure of the grade but needs to be suitable for ca...
7 comments posted 22yrs
posted by a_hole_in_the_ground
7 comments posted 22yrs posted by a_hole_in_the_ground

welding table

Hello everyone I'm looking for plans or suggestions for building a simple and inexpensive gas welding table that can be...
13 comments posted 22yrs
posted by info
13 comments posted 22yrs posted by info

Quick milling machine question

My son is looking into purchasing a small benchtop milling machine and the ones that he has shown me are 4-axis units....
13 comments posted 22yrs
posted by twoblues
13 comments posted 22yrs posted by twoblues

Lincoln Square Wave 300 manuals ?

Hello, I've got this Lincoln Square Wave 300 welder, and it needs a little work. I downloaded the user manual from Linc...
4 comments posted 22yrs
posted by elson
4 comments posted 22yrs posted by elson

FS: Newall DRO Microsyn scale

See http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=3816913863
0 comments posted 22yrs
posted by rasek
0 comments posted 22yrs posted by rasek

Lawn care/trimming

I hate trimming. I have never had a trimmer that advanced the line right. ANyhow. Is there something I can make or use...
8 comments posted 22yrs
posted by ALWAYSLONELY8
8 comments posted 22yrs posted by ALWAYSLONELY8

Fuel Oil Tank to Incinerator

I've got an old ~200 gal. heating fuel oil tank that I want to cut open and turn into an incinerator for brush and dead...
1 comments posted 22yrs
posted by y2k
1 comments posted 22yrs posted by y2k

Preshaped HSS lathe tools?

Perhaps I've overlooking something obvious, but in perusing the MSC, McMaster and Enco catalogs, I've noticed that ther...
5 comments posted 22yrs
posted by i_dont_w
5 comments posted 22yrs posted by i_dont_w