⏣ General Metalworking

30778 Threads Posts
to

5C Collet Dimensions?

Does anyone know where I can find the specs for a 5C collet? I want to make a collet chuck for a lathe. The Machinery Ha...
7 comments posted 22yrs
posted by dberryhill
7 comments posted 22yrs posted by dberryhill

Surface grinder taper info?

Is there a spec available on the web for the taper used on surface grinders? I am looking for the taper on the end of m...
5 comments posted 22yrs
posted by micrio_DELETE_THIS_
5 comments posted 22yrs posted by micrio_DELETE_THIS_

Please help answer my VFD questions

Today I ordered a 5HP VFD from Dealers Electric. It's a Danfoss, I think. New but surplus. $265.00. The best price for...
16 comments posted 22yrs
posted by etpm
16 comments posted 22yrs posted by etpm

4-1/2" cutoff wheel source/quality

I just bought a 4-1/2" 11,000 RPM angle grinder. The prices vary from $1.26 to $3.95 for "metal/steel" cutoff wheels. T...
11 comments posted 22yrs
posted by reply2group
11 comments posted 22yrs posted by reply2group

Propane Tank OPD Valves - Getting Liquid Out

Will liquid propane flow from an inverted (full) 20 lb tank with an OPD valve? I'm guessing it will until the valve flo...
4 comments posted 22yrs
posted by jwisnia
4 comments posted 22yrs posted by jwisnia

I am sure this is a dumb question but

ok today the tooling for my new lathe arrived so I thought I would make some chips the lathe has a 4 way tool post when...
11 comments posted 22yrs
posted by jims
11 comments posted 22yrs posted by jims

Drill Chuck Arbor -- Hardened?

I have a couple of nice MT 3 to JT2 taper arbors I would like to grind or machine down the Morse Taper side to to a 3/4...
6 comments posted 22yrs
posted by stevek
6 comments posted 22yrs posted by stevek

tread dimesions

anyone know were i can find dimensions on different treads the most important right know is 3/8 NPT i have to cut it in...
11 comments posted 22yrs
posted by drag.racer
11 comments posted 22yrs posted by drag.racer

Thanks for the tip on the HP32 calculator!

A few weeks ago, someone suggested using the HP32SII calculator for its fraction capabilities. Thanks for the great sug...
48 comments posted 22yrs
posted by akushner
48 comments posted 22yrs posted by akushner

metal telescope mirror

I recall reading that Newton envented his own telescope, using a mirror which he made out of speculum metal. I would gu...
3 comments posted 22yrs
posted by ara
3 comments posted 22yrs posted by ara

Belt Length for South Bend

I need to order a new flat drive belt for my 13" south bend lathe. I am going to get an endless belt. Can anyone recomm...
2 comments posted 22yrs
posted by jamespev
2 comments posted 22yrs posted by jamespev

Diamond wheels on a surface grinder

A while back we had a good discussion about the various types of stone wheels that could be used on surface grinders. I...
4 comments posted 22yrs
posted by micrio_DELETE_THIS_
4 comments posted 22yrs posted by micrio_DELETE_THIS_

laser level for line on curved surface?

I think a small laser level would help me a lot, but I'm not sure. Let's say that I have a curved surface, a rough hemi...
27 comments posted 22yrs
posted by info
27 comments posted 22yrs posted by info