⏣ General Metalworking

30778 Threads Posts
to

Table dimensions

I'm a newbie who would prefer that all bolts came in two sizes: big and little. I'm getting over it, but slowly. I meas...
9 comments posted 22yrs
posted by Bill
9 comments posted 22yrs posted by Bill

Dyslexic Combination Locks

I obviously have too much time on my hands..... I had to buy SWMBO a combination lock for her health club locker. While...
3 comments posted 22yrs
posted by jwisnia
3 comments posted 22yrs posted by jwisnia

drilling through set screws

At work, I have been given the glorious task of drilling a 1/16 hole through the centre of 1/4-20 set screws. I realize...
15 comments posted 22yrs
posted by tc3
15 comments posted 22yrs posted by tc3

Harbor Freight Angle Grinder casualty

Well, it finally happened. I think my oldest most abused HF 4.5 inch angle grinder finally bit the big one. After count...
7 comments posted 22yrs
posted by ke4zv
7 comments posted 22yrs posted by ke4zv

Interesting RV

Not my auction, just thought some people would like to see it. Don http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewI...
16 comments posted 22yrs
posted by don
16 comments posted 22yrs posted by don

Grinding tungsten

I have just spent about 5 minutes "polishing" the grit on my angle grinder, trying to sharpen the bits on a post hole b...
7 comments posted 22yrs
posted by nsnfwhite
7 comments posted 22yrs posted by nsnfwhite

measuring for a spanner wrench

ok from what point to what point do I use to measure for a spanner wrench? I need a hook type for my LeBlond but have n...
3 comments posted 22yrs
posted by paul
3 comments posted 22yrs posted by paul

Material for Toolmakers Vise?

One of my students wants to make a small toolmakers vise similar to the ones shown at http://metalworking.com/DropBox/T...
9 comments posted 22yrs
posted by errol.groff
9 comments posted 22yrs posted by errol.groff

advice needed on new compressor installation

Greetings, Our factory recently purchased a 20HP Kaeser rotary screw SK26 model. It was used with 800 hours total on it...
19 comments posted 22yrs
posted by deja
19 comments posted 22yrs posted by deja

tool advice request

I plan to learn how to machine and am setting up a shop I am ordering the machines below what I would like to know is w...
5 comments posted 22yrs
posted by jims
5 comments posted 22yrs posted by jims

OT: the truth?

saw this posted on another group.........glad to see not all amerikans have their heads uo their asses....................
0 comments posted 22yrs
posted by birthdayparty
0 comments posted 22yrs posted by birthdayparty

Lots of Holes to Drill

I need to drill about 60 3/8 holes through 3/16th mild steel. I have tried a carbide tipped drill (after a 1/8th pilot...
14 comments posted 22yrs
posted by jeff-klein
14 comments posted 22yrs posted by jeff-klein

Lorch LAS

I have just aquired a Lorch LAS lathe, in need of slight attention & am searching for any information/spares/attachment...
0 comments posted 22yrs
posted by markgengine
0 comments posted 22yrs posted by markgengine

equipment wanted

We are looking for a few pieces of equipment, I'll throw this in here maybe somebody has something sitting in a corner...
0 comments posted 22yrs
posted by al
0 comments posted 22yrs posted by al