⏣ General Metalworking

30778 Threads Posts
to

Looking for thin braded metal security wire

I have a electronic device that I always worry about losing/disappearing of my desk. It has a small hole for a security...
19 comments posted 22yrs
posted by rpm
19 comments posted 22yrs posted by rpm

monster garage had the ultimate project this week

Did anyone see monster garage this week? they built this trike by using a 1972 Peterbilt. This thing was a masterpiece...
17 comments posted 22yrs
posted by seveer
17 comments posted 22yrs posted by seveer

OT: Reagan compared to GWB

While visiting, I was boring my parents with political talk on the subjects of how "likeability" can protect a Presiden...
6 comments posted 22yrs
posted by abrasha
6 comments posted 22yrs posted by abrasha

Bridgeport Mill Question

I have just acquired a bridgeport mill. Is the quill supposed to retract when the lever is released (like on a drill pr...
5 comments posted 22yrs
posted by robert-then
5 comments posted 22yrs posted by robert-then

Bridgeport help with pics and q's

Hi, I'm new to the group. I am venturing over from the rec.ww and owwm. I recently got a Bridgeport knee mill at auctio...
4 comments posted 22yrs
posted by shigeoka
4 comments posted 22yrs posted by shigeoka

OT but lots of metal content

Hello, This is OT but so far I have not received any answers from the pertinent groups where I posted this. The subject...
2 comments posted 22yrs
posted by borism
2 comments posted 22yrs posted by borism
1 comments posted 22yrs
posted by jchrisman
1 comments posted 22yrs posted by jchrisman

OT: value of small business

I've been out of work for about a year now, it's epidemic among engineers up here. Today a guy offered to sell me his b...
33 comments posted 22yrs
posted by grantNOSPAM
33 comments posted 22yrs posted by grantNOSPAM

semi-ot: nice little lathe project?

Every once in a while, I check in over at rec.audio.high-end, mostly for a good laugh -- today was rewarded with this:....
12 comments posted 22yrs
posted by bob.edwards
12 comments posted 22yrs posted by bob.edwards

Van Norman End Mill Questions

I have my Van Norman #12 safely in my garage. I was going through the tooling that came with it and have some basic que...
11 comments posted 22yrs
posted by walter_munney
11 comments posted 22yrs posted by walter_munney