⏣ General Metalworking

30779 Threads Posts
to

Reversing leadscrew on small lathe

I have a small lathe, similar to this one at Harbor Freight ( http://tinyurl.com/yy03 ) except that mine was purchased...
22 comments posted 22yrs
posted by limeylew
22 comments posted 22yrs posted by limeylew

2 AXIS CNC table

I'd like to get a simple, reasonably accurate, lower cost (kit or otherwise) (or used Ebay), X and Y table to use with...
3 comments posted 22yrs
posted by maberger
3 comments posted 22yrs posted by maberger

da bus da bus

Well, we finally got inside da bus and I must say it doesn't look bad. I was surprised that after 2 years there was eno...
1 comments posted 22yrs
posted by PhucDhup
1 comments posted 22yrs posted by PhucDhup

Question: How are ways chromed?

How are ways on machines chromed? Can worn ways be re-chromed and scraped? John
7 comments posted 22yrs
posted by xxxxxxzephyr
7 comments posted 22yrs posted by xxxxxxzephyr

B&S #9 tapper

I have a Brown & Sharp #9 Collet holder and a full set of collets. What machines use this? Before selling I was wonderin...
9 comments posted 22yrs
posted by wayneIHATEJUNK
9 comments posted 22yrs posted by wayneIHATEJUNK

need info on 1020 rivette lathe

i saw a rivette it has 3 shafts. one is a lead screw the other is octagon and then there is a bottom one what is this an...
6 comments posted 22yrs
posted by asp3211968
6 comments posted 22yrs posted by asp3211968

Filling in old swimming pool--some metal content

A neighbor has an old pool which is really poor condition and would like to just fill it in and use the space for somet...
42 comments posted 22yrs
posted by ffredd
42 comments posted 22yrs posted by ffredd

OT - delivering equipment into US from Canada

This weekend, I am driving into the USA to visit some friends. I am also taking a few hand tools and a small lathe to s...
2 comments posted 22yrs
posted by email-rbce2003
2 comments posted 22yrs posted by email-rbce2003

I need a welder

Grr, damn flux isn't working on this rusty 1/4x1 1/4" flat bar... (yeah, I know, clean off the rust, so what.) Plus I b...
9 comments posted 22yrs
posted by tmoranwms
9 comments posted 22yrs posted by tmoranwms

removal of Grade 8 bolt

Arrgh. Have what's left of a Grade 8 bolt,flush with a steel plate. Any ideas how to get it out? Can't get to the back...
22 comments posted 22yrs
posted by invalidjbmiller
22 comments posted 22yrs posted by invalidjbmiller

Sandbags in the bed of a pickup truck

The safety minded individual knows you should secure sandbags in the bed of your pickup truck to reduce the risk of the...
89 comments posted 22yrs
posted by davidw1
89 comments posted 22yrs posted by davidw1