1. Home
  2. ⚙ Model Engineering in the UK
  3. clear casting medium

clear casting medium

Please can anyone give an experience-based recommendation for the above and suitable releasant for a steel mould. The part is a lubricator sight "glass" needing little strength. If possible a reference to a supplier of smallish quantities would also be helpful. thanks

Reply to
Roland Craven
Loading thread data ...

I have no practical experience of this kind of moulding, just ordinary GRP work; try

formatting link
formatting link
(they may not want to deal with small quantities; it depends on how nice the salesperson is) or You can probably get casting resin at your nearest modelling shop, but may be expensive & in v. small amounts.

Both of the companies above do clear polyester cast> Please can anyone give an experience-based recommendation for the above and

Reply to
penfold

John Ambler Sussex, UK Return E-mails to snipped-for-privacy@skiprat.net

formatting link

Reply to
John Ambler

My thanks for the on and off-group replies. After a bit of telephone ping-pong Tirantis were able to advise on a combination that should work. The chap I spoke to was very knowledgeable and helpful.

regards

Reply to
Roland Craven

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.