A while ago I downloaded and installed a small programme called 'workshop'. I still have this programme on one computer, and would like to put a copy off it onto the old computer I now have in the workshop.
I have tried various searches, but have so far drawn a blank as to where I originally found the software (i'm sure it was from a post on this newsgroup). Could somebody supply a link for it?
thanks moray
Why don't you copy it between the two machines ?
-- Regards,
John Stevenson Nottingham, England.
Visit the new Model Engineering adverts page at:-
I'm sure the copy I have came with an installer, but as nobody seems to know about it, I'll try copying the files across and see what happens.
moray
In message , Moray Cuthill writes
I think it will be the software written by Roger Tyrell - I did a bit of "beta testing" on it when it was released.
The files - including the installer are available on the Model Eng. Yahoo group..
Regards,
That's the one. I never thought about checking the yahoo groups.
thanks moray
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.