1. Home
  2. PRO/Engineer (Creo) discussions
  3. How to do section partial in drawing modality

How to do section partial in drawing modality

Hi to everyone, first of all excuse me for my bad english , i'm
italian. I have to do a section partial in drawing modality, exactly
create a breaking and show the hatch into it, besides the boundary must
be dispose to zig zag.
Thank you to all and i hope you understand me!
Paolo
Reply to
bcpolluk72
Loading thread data ...
First, you need a named cross section where you want the breakout section. Make this in the model. Then, in the drawing, create a view where this section will be parallel to the screen. In the section type, pick Local, pick a point for the center of the breakout, sketch a spline as the boundary for the breakout. Click OK and you're done. I'm not sure about "zig zag" but the boundary will be as ragged as your spline.
Reply to
David Janes

Site Timeline

Related

  • Section views in drawing file

  • Can some one provide the steps to create a section view on a drawingsheet for...

  • How to create partial sections

  • I have a two questions about sections: 1. I'd like to create a section in...

  • Add hatch to drawing!

  • HelloI'm using WF 2.0Imagine a rectangle with another rectangle extruded &...

  • Drawing settings - section

  • HiDoes anyone know where the settings of the naming of sections and detailsare...

  • how to redefine a section?

  • How do I redefine a section view on a drawing after I make changes to the model?...

  • Display surfaces in section view on drawing

  • Hi folksI have saved some of my assemblies as parts with only exterior faces to...

  • How to cheange 'Default Model' in drawing?

  • How to cheange 'Default Model' in drawing?Thx

  • How to create section in prt and assembly?

  • Hi I use pro-e 2001. I am new to wf2. How to create section in prt andassembly...

  • How to get sketch dimension in drawing?

  • I would like to dimension the sketch and then have those dimensions show on the...

  • How to move sheet's in a drawing

  • Hello allI have create a drawing with 3 sheet ( sheet1, sheet2, sheet3 )Now I...

  • Block Occupation - Vehicle in Section or Train in Track

  • Hi I know of Rogers circuits, they use though the bridge rectifier to sort...

  • wall on drawing how to?

  • Hello,For documentation I need to place a assembly into his natural enviroment....

  • How to add a model to a drawing in WF2??

  • Hi,How do I add a second model (or assy) in a drawing? I know how to doit in...

  • Partial discharge detection in cables

  • I wish to conduct an experiment to detect partial discharge activityin cable.I...

  • Strange drawing behavior

  • I have got a drawing that has 16 views (named, projected, sections, details,...

  • HELP!!--"model in rollback state, drawing inaccessible"

  • I've got two files open--a part and its drawing. After working on thestupid...

  • How to display surface area in a drawing.

  • I swear I've done this before, or at least something similar..... Iwant to...

  • ISOMETRIC SECTION IN DRAWINGS

  • Is there a way to show an isometric section in a drawing view?In 2004 I have...

  • How to control arrow placement on section line?

  • Which setting controls where the arrow is placed relative to thesection line in...

  • how to convert to PROE to 2D drawing ?

  • I have a assembly file with a lot of parts in PROE format. I need toconvert...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.