Ok I have a DXF I am redoing. I have it open in DWG editor and cut and paste the Sketches I want into sketches in SW but each friggin time I do this the 2d to 3d toolbar pops up. How do I stop this annoyance?
Ben
Ok I have a DXF I am redoing. I have it open in DWG editor and cut and paste the Sketches I want into sketches in SW but each friggin time I do this the 2d to 3d toolbar pops up. How do I stop this annoyance?
Ben
Close your eyes?
Don't think it's possible. It's just another one of those little things where SolidWorks knows better than you how to do things.
=========================================================================== Chris
I, in general, don't find that toolbar to be of any use. Here is how I fixed the annoyance. With the offending toolbar showing, right click the toolbar area and chose "customize". Then drag all the icons from the toolbar into open space, removing them. That leaves you with a 2d to 3d toolbar that is only one square in size. I then docked it so that only its seperator shows on screen. Never notice its there now.
That will work Tank ewe
Ben
Thank you for providing a significantly more helpful response than the one I posted.
It's just sometime the things that are forced upon us by Concord get under my skin a bit.
=========================================================================== Chris
Chris
Anyone who has used SW longer than a day has found more than one annoyance. It is a part of the SW beast that all of us just have to get used to, shouldn't have to but we do.....
Ben
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.