I have SW 2007 SP 0 and FabriWin 10.11.
I open both, load a part file to SW, then switch to FabriWin to use the OLE link. I get a warning in FabriWin that says "Unable to load transfaddin.dll". Transfaddin.dll is in the system/win32 as well as some other directories (for good measure).
Anyone had this problem? Any workarounds?
Thank you.
-- Arif
We're on an earlier version of Fabriwin, but if all you're looking for is the flat pattern, export your SW flat pattern drawing to dxf and then use the FW importer.
Be sure to let FabriWin tech support know too. They've always needed a kick in the b... to get things done.
Diego
arif wrote:
Thanks, Diego.
I was trying to avoid the extra step of DXFs since the part files are already there and I've seen previous posts here of users successfully working with that functionality. I need to get a hold of the FabriWin folks it seems.
-- Arif
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.