How do I get a radial dimension to go through the center mark of an arc with the arrow pointing to the arc?
Everytime I try it, it dimensions to the diameter, not going through the center mark. I want it to dimension through the center mark, to the arc. It does dimension to the arc if I am on one side of the arc, but when I rotate the dimension 180deg, the arrow points to the diameter from outside the diameter circle. I press the arrow, and the arrow changes from outside the diameter, to the arrow pointing from the center mark to the outside diameter, but is pointing the wrong way. I want to to point to the arc.
SW2006
samurai.