Wp,
You should be able to select and edit the 3DSketch if you zoom up close to the curve (when you are far away it's hard to select for some damn reason!?).
If after you want to make them individual curves, the best suggestion I have is make a copy of each using 3DSketch with Convert Edge on each (if you have Rhino3D, you can export/import and it separates them but may lose some data). I posted an example of this here..
formatting link
Also, I posted a version which is controlled by sketches, which gives you more control.
formatting link
BTW, I did not notice this until later but the scale of your boat is way big! (446 feet!) So, you may have to scale it down, not a easy task unless you can export it into something else at the proper scale (not uncommon problem from AutoCrap files, you have to watch the units... or again, if you have Rhino3D, you can scale it there.)?Or, if you want more control, you could scale each of the sketches I have in the second version.
..
Wap-gsm wrote:
> Hi all,
> Is there any way? an AutoCad wireframe model open into SolidWorks 2003
> How can be possible to edit it? Can't select individual line/arc. >
> File is included can someone help?
>
> Best regards
>
> Wp
>
> Name: wireframe_DWG.sldprt
> wireframe_DWG.sldprt Type: SolidWorks Part Document
(application/x-unknown-content-type-SldPart.Document)
Encoding: x-uuencode