You can pick flowers, but you can't pick faces. SW2004

Has anybody run into problems picking faces when using a Section View and TOOLS/SKETCH TOOLS/INTERSECTION CURVE? I am having a heck of a time with this. The face I am trying to pick is on the inside of a revolve which I am exposing with VIEW/DISPLAY/SECTION VIEW.

SW2004 SP4.2. I don't remember having these problems with 4.1 or previous SPs.

Reply to
P
Loading thread data ...

You know i had a similar problem with a flat sheetmetal surface. It worked on all the surfaces I needed except 1. Happened in 2 different assemblies.

Corey

Reply to
Corey Scheich

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.