An Aussie friend of mine is trying to find some answers about these. I have forwarded his ATIS post to this list in case we have anyone wuth the answers!
--------------------------------------------------------------------------------------------------------------------------------- Hi all For those of you that might know a little or a lot about Shearing Plants I have a few questions:
- What speed do the clippers runs at, what RPM on the final drive shaft or down tube shaft.
- When the clippers are attached to the down tube and the tube is hanging vertically, at what angle do the clippers rest on the ground. See photos attached at: formatting linkWhat speed do the grinding discs run at, the disc for honing the cutters. Regards Peter Lowe R&V Engine Registrar Australia Ph: 61-266453455formatting link