⚡ Welding Forums

  1. Home
  2. ⚡ Welding Forums
6251 Threads Posts
to

What to buy with new MIG welder?

I finally made the decision to upgrade from my O/A torch set to a MIG welder. I am going to purchase a Millermatic 175...
13 comments posted 22yrs
posted by junk
13 comments posted 22yrs posted by junk

Miller engine will not start

I have a Miller Bobcat 250 NT w/ Onan engine that well not start. I think it is partly my fault. The gas is not flowing...
3 comments posted 22yrs
posted by dmontez
3 comments posted 22yrs posted by dmontez

CMU class check

Hi guys and gals. Drop me a line and let me know you're reading. Ben
0 comments posted 22yrs
posted by carter
0 comments posted 22yrs posted by carter

Re: New welding technique developed (NIG welding)

> Negro Inert Gas welding is proving to be a fast, cheap method for > fabricating PNL frames here at the AFN factory (l...
13 comments posted 22yrs
posted by garyquiller
13 comments posted 22yrs posted by garyquiller

procedure handbook score!

Well, my wife just brought home an almost unused copy of the Lincoln "Procedure Handbook for Arc welding" from the re-u...
1 comments posted 22yrs
posted by brian.evans
1 comments posted 22yrs posted by brian.evans

Newbie question tig vs mig

Hello folk's. My question is: If i have four exact pieces of 5000 series aluminium to weld together, i weld two togethe...
3 comments posted 22yrs
posted by canicomeinyourundies
3 comments posted 22yrs posted by canicomeinyourundies

Welding AISI430 pot.

Hello, We have a pot of AISI430 which contains nitric melted salt at temperature of about 260 °C. the shape of the sect...
0 comments posted 22yrs
posted by steffy_7691
0 comments posted 22yrs posted by steffy_7691

AISI 439 welding trouble.

Hello, We have a pot of AISI430 which contains nitric melted salt at temperature of about 260 °C. the shape of the sect...
1 comments posted 22yrs
posted by steffy_7691
1 comments posted 22yrs posted by steffy_7691

TIG MACHINE WANTED.

Looking for a used tig machine. Can be broken or not. 220v., 60 hz., single-phase. Must be ac/dc. Thanks Cass
2 comments posted 22yrs
posted by nO3FACD0h______cassegrainian
2 comments posted 22yrs posted by nO3FACD0h______cassegrainian

Expert advice needed - tig filler rod.

I need to build up the edges on numerous small pieces of what appears to be White Iron. Parts are roughly 2" x 3" x 1/2...
1 comments posted 22yrs
posted by jayaresss
1 comments posted 22yrs posted by jayaresss

Miller Snap Start - HF-251 differences??

TIA for any information on the following units: Is the Snap Start able to output continuous HF or is it only for arc st...
1 comments posted 22yrs
posted by no
1 comments posted 22yrs posted by no

Weld penetration with 110 MIG

I have a Lincoln SP135T and have been trying to weld some 3/16" angle. I ground the joints out in a V and still the wel...
18 comments posted 22yrs
posted by
18 comments posted 22yrs posted by