1. Home
  2. ⚙ Mechanical Engineering
  3. Quick Problem: Ball indentation

Quick Problem: Ball indentation

If you drop a 25mm steel ball from a height of 1 meter on to an 1100
aluminum plate (sufficiently thick, long and wide), what is the
indentation that is left by the impact??
----== Posted via Newsfeed.Com - Unlimited-Uncensored-Secure Usenet News==----
formatting link
The #1 Newsgroup Service in the World! >100,000
Newsgroups
---= 19 East/West-Coast Specialized Servers - Total Privacy via Encryption =---
Reply to
problemforyou
Loading thread data ...

Site Timeline

Related

  • Quick Change TP problem

  • I have a Phase II quick change tool post piston type. The problem Ihave with it...

  • Quick Change Toolposts

  • From past posts I see that most people feel the wedge type quickchange toolpost...

  • flanged ball bearings

  • Hi, I noticed some lovely flanged ball bearings in Dennis Clark's book on...

  • Ball Screw Noise - Normal??

  • Thanks for the reply Mark. We purchased the Ball Screw directly fromThompson...

  • abaqus' bouncing rubber ball

  • how do u draw a bouncing rubber ball in abaqus assuming E=2e09 and possion ratio...

  • Bowling ball muller?

  • I've run into a problem with easily re-conditioning my foundry...

  • Ball hopper Lister L

  • Kim,I allways thought the canadian ball hopper listers were rarehere in the UK ...

  • how to make a ball swage

  • I am a lot more of a machinist than a blacksmith. However, I sometimesbeat on...

  • Sources for Cheap Miniature Ball Screws?

  • I've been looking through the interweb and found a few nice miniature ball...

  • Quick change tool posts

  • I have the Aloris version of this, the 16N for negative rakeinserts. It fits...

  • Quick Change Tool Post

  • Hi all - After a very long time I've picked up here again, and have...

  • Ball screw reduction ratio

  • Hi,How can I calculate the reduction ration of a ball screw?For example,...

  • QUICK!

  • I put an ad for a used welder. An old gentleman just called me with a Lincoln...

  • Removing broken hitch ball?

  • section of the ball to see if wedging itIf the jack under the ball stud...

  • Best Quick Change Toolpost for Mini Lathe

  • It's time to get a quick change tool post for my Super C3 mini...

  • QUICK!

  • I put an ad for a used welder. An old gentleman just called me with aLincoln SA...

  • Ball Screws in Bridgeport mill?

  • Yes, ball screws do not provide much resistance. If you mistakenlyleave the Y...

  • Using a ball-check oiler for an air tool

  • I have a air angle grinder that I have a permanent hose whip on (to eliminate...

  • NthreadsP problem

  • I'm trying to use the NthreadsP program to generate gear trains for oddball...

  • Quick Question.

  • Quick question for someone with a "Lister D" book handy. What year was the first...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.