1. Home
  2. ⏣ General Metalworking
  3. Worm Gear Size?

Worm Gear Size?

I need help in find a brass worm gear for an upright bass fiddle. The
gear is brass and 1 3/8 inch diam. by little under 1/4 thick 24 teeth.
How do I measure this to look for replacement?
Reply to
dale randall
Loading thread data ...
Go to Boston Gear
formatting link
and ask them to help.
Joe Gwinn
Reply to
Joseph Gwinn
I would just look for an instrument repair shop.
They prolly have what you want off the shelf. Just a bit more expensive.
DOC
Have robots. Will travel.
formatting link

Reply to
doc

Further Reading

  • Worm gear?

  • Does anyone know where to buy a worm gear and wheel - come to think of it, does...

  • Worm Gear

  • Does anyone have a suggestion as to where I can get a worm gear for a MDC...

  • worm gear cutting success

  • Greetings Tom,Everyone else too.I just uploaded the pics and a text file to the...

  • Worm gear material

  • I dont think that "Rd65 VL22 Copper alloy" is an ASTM designation. Thiscould be...

  • Worm gear material

  • I dont think that "Rd65 VL22 Copper alloy" is an ASTM designation. Thiscould be...

  • worm gear for carriage feed

  • Need a replacement worm gear that is driven by worm on feed rod, about 20DP and...

  • 22 DP 42 tooth worm gear

  • I am working on restoring my 1918 Wade 8A Precision Toolroom Lathe andI found...

  • What might this worm gear fit?

  • I have a 40 tooth Boston worm gear and a couple worms. Would anyoneknow what...

  • Gear Hobbing

  • In the case of hobbing a spur gear, yes, indeed, but in this case it was an...

  • Ridgid R3210 Worm-Gear Circular Saw Review

  • No, I have never used a worm-drive saw. I actually went to Home Depotwith...

  • Gear cutting hob

  • Karl is correct about Ivan Law's book. But if this gear is for a threading...

  • 90 Weight Gear Oil Damaging Brass and Bronze?

  • Someone in the Yahoo 4x6 bandsaw group said they know for a fact thatautomotive...

  • need ideas for worm bearings

  • Hello group,I am looking for a quiet, low friction (low starting and running...

  • What is wrong with this compressor?

  • I'm about ready to purchase a compressor for my power hammer and I'm going...
  • « previous thread

  • OT: How to Make a 25mm Bolt Action Sniper Rifle out of PVC Piping

  • For Gunner and all the other gun freaks. How to Make a 25mm Bolt Action Sniper...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.