⏣ General Metalworking

30777 Threads Posts
to

Need Anilam Wizard Manual or info

I just purchased an old Anilam Wizard, model 112-2 (cheap) on eBay. It seems to work ok but the only manual I can find...
0 comments posted 20yrs
posted by estevew
0 comments posted 20yrs posted by estevew

Casters on an H press?

Speaking of casters. In my ongoing quest to put almost everything on wheels, the 20ton floor standing H press is the ne...
9 comments posted 20yrs
posted by cornerexit
9 comments posted 20yrs posted by cornerexit

help with newly acquired lathe

Hi, i have a few questions if anyone out there would mind taking the time to answer. (question number 3. below is most...
33 comments posted 20yrs
posted by wwixon
33 comments posted 20yrs posted by wwixon

Next tap size up from 3mm

I need to retap something up to the next closest american thread. It was threaded 3 mm. Would that be a 4-40? Thanks, Ro...
4 comments posted 20yrs
posted by rjv494
4 comments posted 20yrs posted by rjv494

Job opening

Might be a "dream job" for the right person...Henry Ford Museum Railroad Specialist Assists with the maintenance and re...
3 comments posted 20yrs
posted by kmiller
3 comments posted 20yrs posted by kmiller

Power supply

I have a Compaq Presario 6010 us about 2-1/2 yrs old. It has XP home -sp2, 736 mb ram, 40 GB hd, 1.4 ghz cpu. Several d...
17 comments posted 20yrs
posted by engineman1
17 comments posted 20yrs posted by engineman1

Holding down work on Mill table

Hi, I am about to try milling for the first time (will practice on scrap material first till I get used to the "feel" o...
9 comments posted 20yrs
posted by webreply
9 comments posted 20yrs posted by webreply

I need a job done

I need a type of bearing made. This is going to look like a lollypop. The round part of the lollypop will have a bearin...
3 comments posted 20yrs
posted by boozoochavez
3 comments posted 20yrs posted by boozoochavez

Square Shank Reamer questions

Are square shank reamers made to work in a drill press or on a lathe? Is there a special chuck for these? What other bi...
7 comments posted 20yrs
posted by gamorris
7 comments posted 20yrs posted by gamorris

Clamping system using shaft collars

Sometime in the last 6 months iirc, someone posted a link where they construced a N degree of freedom clamping system u...
6 comments posted 20yrs
posted by clutch
6 comments posted 20yrs posted by clutch

Best generic welder?

I have an old AC stick welder and have long planned to get a gas welder, but what are the most flexible welders to own...
12 comments posted 20yrs
posted by galt_57
12 comments posted 20yrs posted by galt_57

Is it possible in a garage?

Dear Sirs, please, could you suggest me if it is possible to manufacture a compact mirror like this http://photos.yahoo...
4 comments posted 20yrs
posted by CICCIOBELLOX
4 comments posted 20yrs posted by CICCIOBELLOX

What is it? XCIV

http://puzzlephotos.blogspot.com/ Rob
27 comments posted 20yrs
posted by rhvp67
27 comments posted 20yrs posted by rhvp67