⏣ General Metalworking

30777 Threads Posts
to

Fortress mailboxes

I have been reading about fortress mailboxes (a topic raised here). A couple of conclusions: 1. At least in some places...
49 comments posted 21yrs
posted by ignoramus5275
49 comments posted 21yrs posted by ignoramus5275

"Wood" dust collector for metal dust?

I just got a new G9975 Shop Fox 2 HP Dust Collector. http://www.grizzly.com/products/item.aspx?itemnumber=G9975 I am go...
11 comments posted 21yrs
posted by alexkuzn
11 comments posted 21yrs posted by alexkuzn

Flexible spark resistant duct collecting ducts

I am looking for 4" flexible spark resistant ducts to collect dust from my 2"x72" belt grinder. I could use aluminum du...
3 comments posted 21yrs
posted by alexkuzn
3 comments posted 21yrs posted by alexkuzn

removing spot welds?

Have a few questions here 1) What is the best way to remove spot welds on a car fender? So that I can remove the fender...
8 comments posted 21yrs
posted by NoSpam
8 comments posted 21yrs posted by NoSpam

WW I Machining Advances

The library in the next town over is offering a series on WWI and the topic tomorrow night is Aviation and Manufacturin...
4 comments posted 21yrs
posted by errol.groff
4 comments posted 21yrs posted by errol.groff

Do-All Die filer

I picked up an old do-all die filer does anybody have some pictures and or a manual on these thanks bob
0 comments posted 21yrs
posted by robertholcomb
0 comments posted 21yrs posted by robertholcomb

Leaving machines plugged in

Do you leave your welder, grinder, drill press, lathe, mill, etc. plugged in all the time? We had a lightning strike. L...
10 comments posted 21yrs
posted by aasberry
10 comments posted 21yrs posted by aasberry

Converting ac welder to dc

need plans to convert ac welder to dc thanks andries
7 comments posted 21yrs
posted by ajv
7 comments posted 21yrs posted by ajv

Rusty look

how do you make metal to look as if it have a rusty look./and bronze look thanks andries venter
1 comments posted 21yrs
posted by ajv
1 comments posted 21yrs posted by ajv

Inner Diameter of Hole Too Large for Press Fit

Hi. I have an aluminum piece with a hole. There was a tube pressed into that hole, but I pressed it out and want to ins...
29 comments posted 21yrs
posted by nospam
29 comments posted 21yrs posted by nospam

Source for 3 Phase Motor?

Hi Guys, I am going to make a rotary phase converter and would like to know if anyone can tell me of a good source for...
7 comments posted 21yrs
posted by jbacc
7 comments posted 21yrs posted by jbacc

PING: Dave Hinz

Dave, a while back you said you could post some pics for me re: a key cutter. i've got the pics now, and i've just post...
7 comments posted 21yrs
posted by cusmarsh
7 comments posted 21yrs posted by cusmarsh

Key cutter/Benchmaster MH2 question answered

Thanks to Jim Wilkins, I have been able to identify the mysterious "key cutter". It is the third pic, on the site Jim p...
8 comments posted 21yrs
posted by cusmarsh
8 comments posted 21yrs posted by cusmarsh

A Metalworking Term I never Knew Before

Today's "A Word a Day"* email was this one: **************************************************************** This week'...
15 comments posted 21yrs
posted by jwisnia
15 comments posted 21yrs posted by jwisnia