⏣ General Metalworking

30778 Threads Posts
to

pinging gunner

Hey Gunner, Did you get that auto-dark welding helmet for xmas? ron
1 comments posted 21yrs
posted by doodooron
1 comments posted 21yrs posted by doodooron

Ping Jim Rozen

Hi Jim, I have a 10L with a damaged feed-and-threading chart (the metal one riveted on right above the quick change plu...
1 comments posted 21yrs
posted by peekamoose
1 comments posted 21yrs posted by peekamoose

engine boring on a vertical mill

To all the people who say that I cannot bore a engine block with a vertical mill, let me ask you this: Why cannot I bor...
17 comments posted 21yrs
posted by nattydreadlocks2001
17 comments posted 21yrs posted by nattydreadlocks2001

Metal Lathe

I have a jewelers lathe for sale It is made in Germany I brough it home when I was on vacation over there . My eye site...
7 comments posted 21yrs
posted by runshe1
7 comments posted 21yrs posted by runshe1

Update on Mystery Bolt from Clausing 8540

I took the fastener off of the Clausing 8540 over arm and it is actually a nut and not a bolt. It looks to be either a...
13 comments posted 21yrs
posted by Sierevello
13 comments posted 21yrs posted by Sierevello

New toy-pictures in drop box

An interesting little dohickey followed me home this week, from a shop that is down sizing to smaller quarters. They ev...
18 comments posted 21yrs
posted by gunner
18 comments posted 21yrs posted by gunner

Used Lathe dealers in Phoenix AZ area

I am looking for a used 13" or 16" lathe in the Phoenix AZ area. But the difficult part is I have only a 4' wide place...
3 comments posted 21yrs
posted by rwatson767
3 comments posted 21yrs posted by rwatson767

SOOT: Autotransformer

I am aiming to use a centre-tapped trannie to power a Cobra MIG Wire feeder that I asked about before. The feeder uses...
5 comments posted 21yrs
posted by nsnfwhite
5 comments posted 21yrs posted by nsnfwhite

Help Identifying Bolt

I have 2 bolts on the over arms of my Clausing 8540 Horizontal Mill. I thought at first they were Torx T-60's but I bou...
8 comments posted 21yrs
posted by Sierevello
8 comments posted 21yrs posted by Sierevello

Erector set tool idea

It came to mind some time ago the idea of using 2" square tubing like what's used on trailer hitches to make reconfigur...
3 comments posted 21yrs
posted by cmciver
3 comments posted 21yrs posted by cmciver

Where to Buy a Good Drill Bit Set?

I'm looking for a set with wire sizes, letter, and fractional. There are a lot of 115pc sets a places like Northern too...
16 comments posted 21yrs
posted by freeagentREMOVE
16 comments posted 21yrs posted by freeagentREMOVE

Mending a broken switch stem

I have a particular rotary switch with an about 2mm thick stem. It is made of some sort of steel. The stem on it is bro...
9 comments posted 21yrs
posted by ignoramus31471
9 comments posted 21yrs posted by ignoramus31471

Sharpening Stanley knife blades

I cut copper laminate for making printed circuit boards by scoring it deeply on both sides with a Stanley knife and the...
26 comments posted 21yrs
posted by leon_heller
26 comments posted 21yrs posted by leon_heller