⏣ General Metalworking

30778 Threads Posts
to

Floor Drain

I have a floor drain like this one in the shop. http://www.plumbingdirect.com/Zurnimages/large/FD-2380.jpg This drain h...
24 comments posted 22yrs
posted by shawn_75ATcomcastDOTnet
24 comments posted 22yrs posted by shawn_75ATcomcastDOTnet

How do I post pictures?

I need to brag a little, like everyone else here. I want to show some of my projects, particularly a nice looking gate...
2 comments posted 22yrs
posted by deserttraveler
2 comments posted 22yrs posted by deserttraveler

Clearcoat for metals

Guy Lautard referred me to: www.everbrite.net This sounded so good I had to try some. I've been looking for a good clea...
7 comments posted 22yrs
posted by SPAMBLOCKdforeman
7 comments posted 22yrs posted by SPAMBLOCKdforeman

X-Y table for drill press

I'm looking for the above for two drill presses (not for milling) but can't really find anywhere with a wide selection...
11 comments posted 22yrs
posted by oparr
11 comments posted 22yrs posted by oparr

Jacobs 2A Taper?

Anybody familar with a Jacobs 2A taper? Based on the fat end measurement, it might be a "2 Short", but I can't find any...
3 comments posted 22yrs
posted by chrish57
3 comments posted 22yrs posted by chrish57

Analysis of Gold Types

Hello again folks. Thanks for all who answered my recent questions about gold melting/working, I am now set up and happ...
3 comments posted 22yrs
posted by heather
3 comments posted 22yrs posted by heather

Is this an ok deal for this tig welder?

MILLER SYNCRO WAVE 250 Tig/stick welder, Serial KF880754, foot control, air cooled torch, regulator, stinger lead, HD c...
8 comments posted 22yrs
posted by wrace
8 comments posted 22yrs posted by wrace

Need flat spring stock

I need some flat spring stock for some suspension parts for a trailer. Two pieces, 3/16" thick, 1" wide, 2' long. Where...
1 comments posted 22yrs
posted by mricflo
1 comments posted 22yrs posted by mricflo

concrete block cutting knife source ?

Can anyone (UK) suggest a source for cutting knives 12 " or 24" long for a home brew cement block cutter? I ve previous...
0 comments posted 22yrs
posted by hmcmurray
0 comments posted 22yrs posted by hmcmurray

Furnace Design Question

I'm building an aluminum melt propane furnace in which I may also want to someday melt brass - and maybe even occasiona...
11 comments posted 22yrs
posted by tmayhugh
11 comments posted 22yrs posted by tmayhugh

Needed - S Hooks

I am going to be getting started soon on some projects, and I will be needing some S hooks. I have looked at a million...
4 comments posted 22yrs
posted by deserttraveler
4 comments posted 22yrs posted by deserttraveler

DeWALT bench grinder

I just received a 6 inch DeWALT bench grinder from Enco.MADE IN CHINA. I was surprised. Any one had experience with thes...
2 comments posted 22yrs
posted by waltleroy
2 comments posted 22yrs posted by waltleroy