⏣ General Metalworking

30778 Threads Posts
to

Painting SS

I would appreciate any suggestions on how to successfully paint some SS sheet. The material is 304 that has been graine...
5 comments posted 22yrs
posted by edangell
5 comments posted 22yrs posted by edangell

Lathe Question

A friends dad has a 1977 Atlas 6" Model 3950 lathe for sale. It looks to be in very good condition. Some of the tooling...
29 comments posted 22yrs
posted by jo
29 comments posted 22yrs posted by jo

For Trade - Shaper Keyway/Slotter Tool Holder

I have an Armstrong No. 47 Keyway/Slotter Tool Holder for a shaper that I would like to trade for a smaller Armstrong K...
0 comments posted 22yrs
posted by craftsman_ron
0 comments posted 22yrs posted by craftsman_ron

Best tig welder in the world

HTP invertig 200. Puts out 200A ac and dc,both tig and stick, at up to 200hz at full power, draws 30A max from the wall...
1 comments posted 22yrs
posted by bpw67deletethis
1 comments posted 22yrs posted by bpw67deletethis

Building Gloat

After years of looking, finagling, trying and missing, we have a building. In the front is a 1500' office suitable for...
5 comments posted 22yrs
posted by mlogical
5 comments posted 22yrs posted by mlogical

OT Removing snapped off shelf bracket

Over time, the little plastic shelf brackets supporting the shelves in our kitchen cabinets have been snapping off, lea...
3 comments posted 22yrs
posted by jwisnia
3 comments posted 22yrs posted by jwisnia

Ram EDM troubles

I was trying to use my Southbend/Ingersoll/Hansvedt 150B Ram EDM over the weekend and ran into some difficulty. Maybe s...
10 comments posted 22yrs
posted by al2001block
10 comments posted 22yrs posted by al2001block

Oddball old torch

I have in my possession this strange old torch. This is a bench mount model, not hand held. It has a small cast iron tr...
2 comments posted 22yrs
posted by jski
2 comments posted 22yrs posted by jski

Taig Lathe Question

HI All: I'm thinking of getting a Taig based on recommendations from clock repairers. It seems like a good tool but loo...
5 comments posted 22yrs
posted by finitetheelement.guy
5 comments posted 22yrs posted by finitetheelement.guy

OT- Food Preserving FAQ Available

for those of you who like to eat well and cook well: >The rec.food.preserving FAQ is available at > http://www.gbronlin...
0 comments posted 22yrs
posted by gunner
0 comments posted 22yrs posted by gunner

Magnetic Chuck Repair Question

I have just obtained a 6 X 18 magnetic chuck. I think the brand is Walker, but I can't tell for sure because the namepl...
2 comments posted 22yrs
posted by xxxxxxzephyr
2 comments posted 22yrs posted by xxxxxxzephyr

Ultimate Compliment

They are laying a natural gas pipeline a mile or so south of here. I'm out in the shop this morning when they set of a...
15 comments posted 22yrs
posted by andyasberry
15 comments posted 22yrs posted by andyasberry