⏣ General Metalworking

  1. Home
  2. ⏣ General Metalworking
30776 Threads Posts
to

Worth reading in ⏣ General Metalworking

"Air Hammer Quick Release Chisel Holder"

Such as this one: http://www.harborfreight.com/air-tools/air-tool-accessories/air-hammer-quick-release-chisel-holder-66...
0 comments posted 14yrs
posted by bobengelhardt
0 comments posted 14yrs posted by bobengelhardt

What is it? Set 461

http://55tools.blogspot.com/ Rob
23 comments posted 14yrs
posted by rhvp65
23 comments posted 14yrs posted by rhvp65

Pete C / Don N - Paper

I think it was one of you two who told me about using a sheet of paper for a non-slip interface between flat metal obje...
2 comments posted 14yrs
posted by none
2 comments posted 14yrs posted by none

Marines with no live ammo

Oct 02, 2012 One of the guys on the radio says that the Marines who responded to the bombing in Cairo were not "permitt...
23 comments posted 14yrs
posted by cayoung61***spamblock
23 comments posted 14yrs posted by cayoung61***spamblock

A good day with a gun hater

I thought I'd copy this email to RCM. guess who its from Karl Sunday 30 Sept 2012 was a splendidly gorgeous autumn day...
36 comments posted 14yrs
posted by karltownsend.NOT
36 comments posted 14yrs posted by karltownsend.NOT

Anyone want any NOS phone jacks?

Going through the cargo container and found a bunch of phone jacks. I think there are 12 or so Levitron WHITE 4 cond fl...
0 comments posted 14yrs
posted by gunnerasch
0 comments posted 14yrs posted by gunnerasch

power control

I'm lining up my winter shop projects already... I plan to upgrade a horrible fright 220 volt spot welder with a weld t...
27 comments posted 14yrs
posted by karltownsend.NOT
27 comments posted 14yrs posted by karltownsend.NOT

Practical Machinist Website

Sorry for the Off-Politics Post. Has anyone tried to get to the PracticalMachinist.com website for the last few days? I...
6 comments posted 14yrs
posted by 3t3d
6 comments posted 14yrs posted by 3t3d

bender

I want to bend some cold rolled 3/4" round rod. I just need to bend them to degrees less than 45 degrees. Would a bench...
3 comments posted 14yrs
posted by steveb
3 comments posted 14yrs posted by steveb

Power steering experience

Had a work truck once. The power steering was leaking. I had a can of something other....... brake fluid, tranny fluid,...
4 comments posted 14yrs
posted by steveb
4 comments posted 14yrs posted by steveb

Knife Making

Any knife makers/smiths out there?
0 comments posted 14yrs
posted by Jim.L..aae08e8
0 comments posted 14yrs posted by Jim.L..aae08e8

lead bullet making

I thought about just emailing the RCM premier expert on bullet casting, but maybe somebody else has something to add. A...
33 comments posted 14yrs
posted by karltownsend.NOT
33 comments posted 14yrs posted by karltownsend.NOT

Split Point Drill Bits

Does anyone have a link to a good picture of a split-point drill bit? I've been looking, and all I see are side views -...
7 comments posted 14yrs
posted by tim
7 comments posted 14yrs posted by tim