⏣ General Metalworking

  1. Home
  2. ⏣ General Metalworking
30777 Threads Posts
to

Worth reading in ⏣ General Metalworking

Pacemakers and welding

Here's a very good article on this subject. Cardiac pacemakers are electronic devices with sensing circuits which detec...
30 comments posted 17yrs
posted by ignoramus6829
30 comments posted 17yrs posted by ignoramus6829

Lifting B'port series I R2E4 BOSS-9

I have my 'new' mill sitting just outside the milling room on a 4' high trailer. I can have a friend with a boom lift p...
34 comments posted 17yrs
posted by lloydspinsidemindspring.com
34 comments posted 17yrs posted by lloydspinsidemindspring.com

Supplier for Helicoil hardware

I require some bulk thread inserts and replacement taps for a few helicoil sets we use here in the shop all the time......
3 comments posted 17yrs
posted by rbce2003
3 comments posted 17yrs posted by rbce2003

White gas?

I snagged a Therm'X Safety Heater model 30-C on Ebay, brand new. It's a catalytic gauze burner type from the '60's. the...
22 comments posted 17yrs
posted by junkjasonrnorth
22 comments posted 17yrs posted by junkjasonrnorth

PYH Rotary Table Index/Dividing Plate Set

I bought a plate set that was said to be for a 6" Rotary Table, but I haven't found a reference to the PYH brand. I exp...
2 comments posted 17yrs
posted by wb_wildbill
2 comments posted 17yrs posted by wb_wildbill

Best bench setup for hand sharpening drill bits

I have picked up 2 of those General drill bit jigs that mount next to a bench grinder, I need to know the best setup fo...
13 comments posted 17yrs
posted by tucker
13 comments posted 17yrs posted by tucker

Bridgeport QuillMaster attachment and N2 collets

I would really appreciate it if someone could shed light on this. 1. What are the collets for bridgeport Quillmaster att...
2 comments posted 17yrs
posted by ignoramus10831
2 comments posted 17yrs posted by ignoramus10831

Minor page update

--Finally got some photos of the calliope project posted. More to follow in a day or so. Current need: about 4ft of 1-1...
0 comments posted 17yrs
posted by steamer
0 comments posted 17yrs posted by steamer

Connectors for Jenix DROs sought

I put a Jenix DRO on my Millrite vertical mill. I would like to add a Z-axis switch, choosing between the knee vertical...
12 comments posted 17yrs
posted by joegwinn
12 comments posted 17yrs posted by joegwinn

Honda Headscratching

Ive been trying to get that '74 Honda XL 350 to run properly...with no luck. Pulled the carby tonight checked everythin...
46 comments posted 17yrs
posted by gunner
46 comments posted 17yrs posted by gunner

need some Valenite help

I bought some Valenite indexable holders, specifically these: http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=2...
3 comments posted 17yrs
posted by nobody
3 comments posted 17yrs posted by nobody