⏣ General Metalworking

  1. Home
  2. ⏣ General Metalworking
30776 Threads Posts
to

Worth reading in ⏣ General Metalworking

Re: Joshua Rose, Modern Machine Shop Practice (1887)

> Hello all, > > I know it's been a long while, but I'm finally done scanning > volume 1 of Joshua Rose's wonderful 188...
3 comments posted 7yrs
posted by ramblingrosebud
3 comments posted 7yrs posted by ramblingrosebud

Steel Soft Jaws (2025 Update)

I have a few pair of aluminum soft jaws left. Bought a bulk pack of them from Monster Jaws or somebody like that a numb...
0 comments posted 7yrs
posted by none
0 comments posted 7yrs posted by none

Way Covers & Chip Removal (2025 Update)

Way Covers & Chip Removal ????????????? Alrighty now. The old Blue Beast was brought back into operation yesterday. (My...
0 comments posted 7yrs
posted by none
0 comments posted 7yrs posted by none

Combination 4 Jaw Chuck (2025 Update)

I I've never seen a chuck like this, but if I had one setting it up to go on my lathe would be really close to project...
0 comments posted 7yrs
posted by none
0 comments posted 7yrs posted by none

Grizzly G4011 30" Sheet Metal Machine

/Hello, I just Picked up a Grizzly G4011 3in 1 Brake Shear Roll machine. When I got it home, I tried to rotate the cran...
7 comments posted 7yrs
posted by eacars
7 comments posted 7yrs posted by eacars

beryllium copper

I have some BeCu strip [ 1" x .020 ] that I would like to make into a loop to check the co-planerness of a chiwan 4x6....
3 comments posted 7yrs
posted by email
3 comments posted 7yrs posted by email

Taper Lock Timing Pulley (2025 Update)

I was just getting ready to put a machine back in service, but I had changed the diameter of the end of the Y axis ball...
0 comments posted 7yrs
posted by none
0 comments posted 7yrs posted by none

1939/40 Harley trans questions (2025 Update)

It was oh so well fitted in the '39 tranny case ... the main clutch gear/thrust bearing race . Had a perfect fit , roll...
6 comments posted 7yrs
posted by snag_one
6 comments posted 7yrs posted by snag_one

TIG, metal cutting, pneumaforming (2025 Update)

If nothing else, watch the first minute of This Old Tony's video. https://www.youtube.com/watch?v=aGsFdudG7HoFascinatin...
1 comments posted 7yrs
posted by ljaques
1 comments posted 7yrs posted by ljaques

TIG brazing (2025 Update)

Miller has a useful, short article on TIG brazing with silicon bronze up on their website: http://tinyurl.com/y6xhcxa4 I...
1 comments posted 7yrs
posted by huntres23
1 comments posted 7yrs posted by huntres23

Recycling 6061 - Thought chain (2025 Update)

Ok.. I've studied on this for a while. Everybody says (exaggeration) you can't cast 6061 it has to be wrought. If you t...
0 comments posted 7yrs
posted by none
0 comments posted 7yrs posted by none

millermatic 175

machine will run for three minutes then shuts down for five minutes with the machine under no load,is there a thermo swi...
1 comments posted 7yrs
posted by Kenny Stevens
1 comments posted 7yrs posted by Kenny Stevens