⏣ General Metalworking

  1. Home
  2. ⏣ General Metalworking
30777 Threads Posts
to

Worth reading in ⏣ General Metalworking

APBA site for 1950 Lake Mead Race

http://www.lesliefield.com/races/1950_apba_unlimited_trophy_the_fifth_annual_lake_mead_regatta.htm
0 comments posted 19yrs
posted by oldfart
0 comments posted 19yrs posted by oldfart

co2 - safe handling?

Just got myself a co2 tank designed to fill small paintball tanks. I plan to use this mostly for combat robotics and po...
12 comments posted 19yrs
posted by doc
12 comments posted 19yrs posted by doc

Disassembling a leaded cast iron pumbing joint?

Greetings all The house I am currently renovating has a plumbing problem that I need to correct. Someone in the past ha...
11 comments posted 19yrs
posted by aribert
11 comments posted 19yrs posted by aribert

Tumbling sand

I broke out an old tumbling machine to tumble some dies and other things that have gotten rusty on me. What would be a...
12 comments posted 19yrs
posted by oldfart
12 comments posted 19yrs posted by oldfart

OT: Ratcheting bearing?

(I'm not sure where this would be on topic) I need something to help drive a wheel. A bearing will be stuck on a shaft...
32 comments posted 19yrs
posted by jdoe
32 comments posted 19yrs posted by jdoe

Where to find steel wedges?

Sometime back I was given a couple steel wedges, just hard flat steel about 1" wide, 1/4" thick at the fat end and tape...
11 comments posted 19yrs
posted by wally
11 comments posted 19yrs posted by wally

Please help!

hi gang!, I'm a 21 yo student, and I'm struggling for money. I have a web site parked up for pay per click advertising,...
3 comments posted 19yrs
posted by laffo.co.uk
3 comments posted 19yrs posted by laffo.co.uk

Gingery mill/lathe page up

Greetings folks! I have put up some photos of my progress with the Gingery lathe so far. Being my first webpage ever, t...
3 comments posted 19yrs
posted by ceramosb
3 comments posted 19yrs posted by ceramosb

Wireless Networking

I have a CNC lathe running with EMC2 under Linux. My home network is on the East side of my house and my shop is on the...
15 comments posted 19yrs
posted by regor
15 comments posted 19yrs posted by regor

Clarke CL500M lathe / mil

Hi I have recently brought a second hand Clarke CL500M lathe/mill. The mill head has a milling chuck that takes collets...
5 comments posted 19yrs
posted by jassira_remove_this_bit_53
5 comments posted 19yrs posted by jassira_remove_this_bit_53

What is it? CXCIII

http://puzzlephotos.blogspot.com/ Rob
22 comments posted 19yrs
posted by rhvp67
22 comments posted 19yrs posted by rhvp67

240 lbs set of parallels or railroad rails

This item, shockingly, weighs 240 lbs and has four sturdy carry handles on it. It looks on the first sight to be a litt...
3 comments posted 19yrs
posted by ignoramus24409
3 comments posted 19yrs posted by ignoramus24409

Rifle toting robots go into battles in Iraq

This robot looks just like the battlebots on TV. A very interesting concept. Potentially the soldier can be sitting in...
59 comments posted 19yrs
posted by ignoramus24409
59 comments posted 19yrs posted by ignoramus24409