Vince up the road has just popped in, he needs a Colchester fitting 4-Jaw chuck to fit a Colchester Bantam lathe, and needs it here for tomorrow sometime.
I'm going to Burton on Trent in the morning, so will be travelling past John S's place, or what is available?
Peter
-- Peter A Forbes Prepair Ltd, Luton, UK snipped-for-privacy@easynet.co.uk
Sounds like you mean a D1-3 camlock.. He could of just ordered one from J&L if he wanted one to keep, and the cost was not out of the question.
The chipmaster uses the same fitting...
Got a chuck but no spare backplate.
-- Regards,
John Stevenson Nottingham, England.
Visit the new Model Engineering adverts page at:-
Too late for tomorrow, but I do have a spare D1-3 4-jaw. Only available if you collect this ****** Ward lathe, though
Tim
Dutton Dry-Dock Traditional & Modern canal craft repairs Vintage diesel engine service
If only you knew..... :-))
I'll be in touch re the collection, the trailer is hors de combat due to something unforeseen (don't ask!)
What size is the chuck?
Peter
-- Peter & Rita Forbes Email: snipped-for-privacy@easynet.co.uk Web:
Have something to add? Share your thoughts — no account required.
Ask the community — no account required