Cross Feed for Tom Senior E

Oct 03, 2007 3 Replies
Y

Cross Feed for Tom Senior E


Hallo I do own one of those Tom Senior E Milling Machines. It has a powe cross feed, controlled by a fairly old electronic by a company calle LENZE. That system has failed and dispite the efforts of some peopl trained in this area it seems to be beyond repair.



Can onyone suggest a modern control system that could be used as replacement using the same motor?



Many thanks Johanne


-- Yorkshireman4



----------------------------------------------------------------------- Yorkshireman48's Profile:

formatting link
this thread:
formatting link


Vote
Twitter Facebook LinkedIn
M

What type of electric motor is it

-- Myford Mat

----------------------------------------------------------------------- Myford Matt's Profile:

formatting link
this thread:
formatting link

Vote
Twitter Facebook LinkedIn
Y

The motor has this on the label

Chemo AG Ch-4132 Muttenz

GN M 551.10.3.2.5 Typ

100 WL

54028 Mnr

F 210 =V 0.17 A A 180 =V 0.90 A

1/min 4000

So it is a direct current motor (from Switzerland).

Hope this brings us a bit further. Thanks Johanne

-- Yorkshireman4

----------------------------------------------------------------------- Yorkshireman48's Profile:

formatting link
this thread:
formatting link

Vote
Twitter Facebook LinkedIn
M

I'd have thought pretty much any DC controller that powers rotor an

stator - Eurotherm make nice controllers

-- Myford Mat

----------------------------------------------------------------------- Myford Matt's Profile:

formatting link
this thread:
formatting link

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required