1. Home
  2. PRO/Engineer (Creo) discussions
  3. How to turn off planes, axes, etc. in config.pro?

How to turn off planes, axes, etc. in config.pro?

I'm sure it's simple, but how do you set your default display for planes, axes, points, etc. to be off in your config.pro?

Thanks Todd snipped-for-privacy@yahoo.com

Reply to
T Bennett
Loading thread data ...

Use the Find function in the options dialog, search for "display" (w/o quotes). Most of those will come up toward the top of the list.

Reply to
Jeff Howard

datum_display NO datum_point_display NO display_coordinate_sys NO spin_center_display NO tangent_edge_display NO

Reply to
Ants

Thank you.

Todd

Reply to
T Bennett

T, yah sure they are just config.pro settings like this

display_planes n

display_coordinate_sys n display_points n display_axes n

These would be for Wildfire & 2.

Hope this helps, Glenn |B

Reply to
GWDavis28

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.