* IN ASSEMBLY VIEW BALLOON?

Forgive if it's been asked before. What does it mean when you have an asterisk (*) in a balloon on an assembly view of a drawing? I can set the balloon to custom and then back to item number and it is correct until you do a rebuild, then it goes back to being an asterisk...

TIA, Jeff

Reply to
Not Necessarily Me
Loading thread data ...

"Not Necessarily Me" wrote What does it mean when you have an

The component you are ballooning is probably not in the BOM that is being referenced. This can happen if, for example, you are using assembly configs and the component is suppressed in the config on which the BOM is based.

John H

Reply to
John H

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.