⚡ Welding Forums

  1. Home
  2. ⚡ Welding Forums
6251 Threads Posts
to

Welding Aluminum Tube 6061 T6 0.065 wall

I tried welding some aluminum tube last night without any luck. For one it was the first time I ever tried AL welding w...
5 comments posted 18yrs
posted by
5 comments posted 18yrs posted by

Pancakes

Welding masks is a thread already. Who's seen the old pancake masks? I knew some old pipeliners who swore by them and wo...
6 comments posted 18yrs
posted by oldfart
6 comments posted 18yrs posted by oldfart

new steel mill

Our company just completed installing a huge allotment of equipment at the first greenfield mill start up built in alon...
7 comments posted 18yrs
posted by williamhenry
7 comments posted 18yrs posted by williamhenry

Set-up to weld around a cylinder

I have a small, light load-bearing shaft about 5' long and about 1" dia. that I have to weld around the circumference i...
4 comments posted 18yrs
posted by vrstull
4 comments posted 18yrs posted by vrstull

Zodiac 2008 - Geomancy Hut

Hi, please visit "www.geomancyhut.com.sg" to obtain your Zodiac predictions for 2008 if you are keen know what has insto...
0 comments posted 18yrs
posted by geomancyhut
0 comments posted 18yrs posted by geomancyhut

Micro TIG

I got some ceriated .020 electrodes and collet today and tried them out. I get a really nice 3/16 wide bead, butt weldi...
2 comments posted 18yrs
posted by spam
2 comments posted 18yrs posted by spam

Engines

Kohler, Robin/Subaru, Honda ....... others ....... What's the best engine for a Lincoln welder in the Ranger 250 class?...
12 comments posted 18yrs
posted by deserttraveler
12 comments posted 18yrs posted by deserttraveler

Carbon absorption by S.S.

Let me apologize if this is too off topic for this group but I do read you guys talking about carbon content, etc. I bu...
2 comments posted 18yrs
posted by b_paige_125
2 comments posted 18yrs posted by b_paige_125

to braze or tig

hello all, been gone a while and quite sad to see all of the spam on the group using Thunderbird to read it. ok to the...
2 comments posted 18yrs
posted by williamhenry
2 comments posted 18yrs posted by williamhenry

welder idle control?

I have an old Miller welder with a bad idle control module. It's supposed to energize an electromagnet-type (pull) sole...
27 comments posted 18yrs
posted by grant
27 comments posted 18yrs posted by grant

Torch popping

I bought a used Victor. Just got it all going, and it pops every two or three seconds. Doesn't pop when the 02 handle i...
4 comments posted 18yrs
posted by deserttraveler
4 comments posted 18yrs posted by deserttraveler

Homegrown air dryer idea - don't laugh please

I have read many articles about folks using well-designed relay-driven fans and intercoolers, etc. to cool their shop a...
9 comments posted 18yrs
posted by spamdoctor
9 comments posted 18yrs posted by spamdoctor