Does anyone know of a good stand-alone, freeware program to batch convert
dwg to pdf.
- posted
15 years ago
dwg>pdf
Loading thread data ...
- posted
15 years ago
The best way is usually to publish/plot to a pdf print driver. There are
many such drivers out there (CutePDF, PrimoPDF, etc.) However batch
conversion can be a problem especially when one drawing has multiple
pages. The choice can be quite dependent on the methods you use in drawing.
Chuck Fluri wrote:
Chuck Fluri wrote:
- posted
15 years ago
Oui,
Love it.
Jeannette
formatting link
It converts from dwg to pdf and also between version of dwg and dxf.Love it.
Jeannette
- posted
15 years ago
Jeannette,
Ooops! That program is $69+. Not so free.
Sparky
- posted
15 years ago
I use PDFCreator (
only limitation which can be slightly annoying is you cannot afaik rotate the drawing, but hey, its free!!
formatting link
)only limitation which can be slightly annoying is you cannot afaik rotate the drawing, but hey, its free!!
- posted
15 years ago
I finally bought pdf995
formatting link
is free, but i needed to make many plots, so the advertise coming
used to be boring
so it's only 19$ for full
Because pdfcreator wasent as functional, and was very heavy.
- posted
15 years ago
Take a look at
Remo Shiva a écrit : I finally bought pdf995
formatting link
there a hundreds of free/shareware Programs there that should suite you needs/pockets.Remo Shiva a écrit : I finally bought pdf995
formatting link
It is free, but i needed to make many plots, so the advertise coming
used to be boring
so it's only 19$ for full
Because pdfcreator wasent as functional, and was very heavy.- posted
15 years ago
I use pdfFactory Pro 2.50.
- posted
15 years ago
PDFcreator