X-sectioning in wildfire 2.0

Hi,
since i am in position to create some cross sections in
different level in each quarter of the part in a single view.It
means,if you have seen a cylindrical part on its top view,you are
needed to see different cross section in each quarter (i.e all cross
sections should not be same).
plz guide me to acheive this...
Thanks in advance.
Regards,
sathish
Reply to
sathish
Loading thread data ...
Check the Help files, under Sections, for Offset section (section creation in the model), Full align and Full unfold (section display in the drawing). I suspect that what you are trying to display can be accomplished with one of these.
David Janes
Reply to
David Janes

Site Timeline

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.