1. Home
  2. Scale modeling discussions
  3. Mr Surfacer ???

Mr Surfacer ???

How do you prevent spider webs when airbrushing Mr Surfacer 1000? I am using
a Paasche Model H at about 25 psi and thinned with lacquer thinner. Any help
will be greatly appreciated. Pete
Reply to
The Laws
Loading thread data ...
Your air pressure is way too high. Back off to between 10 and 15 psi, lay on light coats, within 4-5 inches of the surface of the model.
Lee
Reply to
Lee

Further Reading

  • Mr. Surfacer Spider Webs

  • I've always had small problems with spider webs when using Mr. Surfacer. But...

  • Mr Surfacer

  • Just bought a bottle of Mr Surfacer 1000 but the label is in Japanese.Can anyone...

  • Mr. Surfacer Thinner?

  • I would like to spray the Mr. Surfacer 1000 I've got and know there's a...

  • Thinning Mr Surfacer

  • Hi all,Just a question, how do you thin Gunze's Mr Surfacer? Do you use...

  • Mr Surfacer Problem

  • I am spraying Mr Surfacer 1000 as a primer/barrier prior to applying Alclad II....

  • Question about Mr. Surfacer

  • A month or so ago, I posted asking about Gunze paints. I still haven't shot...

  • Mr Surfacer 1000 problems

  • I sent this before but it never hit the NGI tried airbrushing Mr. Surfacer 1000...

  • Mr. Surfacer as primer?

  • Saludos Amigos!I was about to order some of Gunze's Mr. Surfacer from...

  • Filling/Mr Surfacer question

  • I have a model which is almost finished, however it has 2 sinkmarks that are ...

  • Mr Surfacer?

  • I've never bothered with it. You can home-brew something very similarAnd...

  • Mr. Surfacer 500 - available? Substitutes?

  • I tried ordering Mr. Surfacer 1000 and 500 from my local hobby shop; only...

  • Re: Mr Surfacer Questions

  • The way I think of it is: 500 can hide the scuff marks from 500-grit...

  • Re: Mr. Surfacer Thinner Ratio

  • Don't thin it at all if you're applying it to small areas to fill...

  • On-Line Sources for Mr. Surfacer & Tamiya Putty?

  • Any recommended on-line sources to purchase Mr. Surfacer and Tamiya...

  • Will Mr. Surfacer make smooth metal look cast?

  • Hi all,I've found info on making smooth plastic look cast with Mr....

  • OT: Help troubleshooting network gaming lag

  • Running Jane's usaf on two computers, have SERIOUS lag issues. Fixes already...
  • « previous thread

  • Anyone Email Monstersinmotion.com?

  • I've tried it a couple of times myself. Never got a reply. Kind of annoying....
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.