The Italeri kit kit has the Chevrolet cab13 .It has a lot of detail .IMHO is a better kit than the Tamiya kit .
The Ford had side valve v8 engine and vertically split differential housings where as the Chevy was fitted with an inline six cylinder engine and had conventional type differential housings .
The Quad was made by both GM and Ford to quite rigid military spec, at a glance the two look almost identical but there are notable differences on the front ends, if you are in Melbourne try heading down the freeway past Traralgon, turn down C105 (Maffra Rd) and a few clicks down the road you'll see a farm with a couple of ex RAAF Chevy Blitz trucks (from which the quads were derived) parked in it... the guy who owns it is a mad keen military vehicle collector and has from memory a couple of the Ford equivalent there also.
Tak,
Try
Good luck!
Richard
Thx Lads, Bluey, I didn't know there was a Italeri kit, will keep and eye out for it. Umineko, Will be retired (temporarily) soon so will have plenty of time to check out the farm. will see if I can get a few pics too. Rich, heading over the site now ;o)
Try
Good luck!
Richard
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.