I'm using SP 4.0.
I am dimensioning a drawing using both English and Metric units. On some dimensions I cannot change the precision. I've tried everything and it will only display with no significant places. Am I going crazy?
Any suggestions?
I'm using SP 4.0.
I am dimensioning a drawing using both English and Metric units. On some dimensions I cannot change the precision. I've tried everything and it will only display with no significant places. Am I going crazy?
Any suggestions?
Try this. Go to Document Properties/Detailing and set Trailing zeroes to show, rather than smart.
WT
Aarrrggghhhhhhhhh!
Thanks Wayne! I owe you beers.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.